Energy Potential of Empty Fruit Bunches

EFBA palm oil plantation yields huge amount of biomass wastes in the form of empty fruit bunches (EFB), palm oil mill effluent (POME) and palm kernel shell (PKS). In a typical palm oil mill, empty fruit bunches are available in abundance as fibrous material of purely biological origin. Energy potential of empty fruit bunches is attractive as it contains neither chemical nor mineral additives, and depending on proper handling operations at the mill, it is free from foreign elements such as gravel, nails, wood residues, waste etc.

However, EFB is saturated with water due to the biological growth combined with the steam sterilization at the mill. Since the moisture content in EFB is around 67%, pre-processing is necessary before EFB can be considered as a good fuel.

Unprocessed EFB is available as very wet whole empty fruit bunches each weighing several kilograms while processed EFB is a fibrous material with fiber length of 10-20 cm and reduced moisture content of 30-50%. Additional processing steps can reduce fiber length to around 5 cm and the material can also be processed into bales, pellets or pulverized form after drying.

There is a large potential of transforming EFB into renewable energy resource that could meet the existing energy demand of palm oil mills or other industries as well as to promote sustainability in the palm oil industry. Pre-treatment steps such as shredding/chipping and dewatering (screw pressing or drying) are necessary in order to improve the fuel property of EFB.

Pre-processing of EFB will greatly improve its handling properties and reduce the transportation cost to the end user i.e. power plant. Under such scenario, kernel shells and mesocarp fibres which are currently utilized for providing heat for mills can be relieved for other uses off-site with higher economic returns for palm oil millers.

The fuel could either be prepared by the mills before sell to the power plants, or handled by the end users based on their own requirements.  Besides, centralized EFB collection and pre-processing system could be considered as a component in EFB supply chain. It is evident that the mapping of available EFB resources would be useful for EFB resource supply chain improvement. This is particular important as there are many different competitive usages. With proper mapping, assessment of better logistics and EFB resource planning can lead to better cost effectiveness for both supplier and user of the EFB.

A covered yard is necessary to store and supply a constant amount of this biomass resource to the energy sector. Storage time should however be short, e.g. 5 days, as the product; even with 45% moisture is vulnerable to natural decay through fungi or bacterial processes. This gives handling and health problems due to fungi spores, but it also contributes through a loss of dry matter trough biological degradation. Transportation of EFB is recommended in open trucks with high sides which can be capable of carrying an acceptable tonnage of this low-density biomass waste.

For EFB utilization in power stations, the supply chain is characterized by size reduction, drying and pressing into bales. This may result in significantly higher processing costs but transport costs are reduced. For use in co-firing in power plants this would be the best solution, as equipment for fuel handling in the power plant could operate with very high reliability having eliminated all problems associated with the handling of a moist, fibrous fuel in bulk.