On an average 1.5 tons of crop residue are generated for processing 1 ton of the main product. In addition, substantial quantities of secondary residues are produced in agro-industries processing farm produce such as paddy, sugarcane, coconut, fruits and vegetables.

Agricultural residues often have a disposal cost associated with them. Therefore, the “waste-to-energy” conversion processes for heat and power generation, and even in some cases for transport fuel production, can have good economic and market potential. They have value particularly in rural community applications, and are used widely in countries such as Sweden, Denmark, Netherlands, USA, Canada, Austria and Finland.

The energy density and physical properties of agricultural biomass wastes are critical factors for feedstock considerations and need to be understood in order to match a feedstock and processing technology.

There are six generic biomass processing technologies based on direct combustion (for power), anaerobic digestion (for methane-rich biogas), fermentation (of sugars for alcohols), oil exaction (for biodiesel), pyrolysis (for biochar, gas and oils) and gasification (for carbon monoxide and hydrogen-rich syngas). These technologies can then be followed by an array of secondary treatments (stabilization, dewatering, upgrading, refining) depending on specific final products.

It is well-known that power plants based on baled crop residues are efficient and cost-effective energy generators. Residues such as Rice Husks, Wheat Straw and Maize Cobs are already concentrated at a point where it is an easily exploitable source of energy, particularly if it can be utilized on-site to provide combined heat and power.

The selection of processing technologies needs to be aligned to the nature and structure of the biomass feedstock and the desired project outputs. It can be seen that direct combustion or gasification of biomass are appropriate when heat and power are required.

Anaerobic digestion, fermentation and oil extraction are suitable when specific biomass wastes are available that have easily extractable oils and sugars or high water contents. On the other hand, only thermal processing of biomass by pyrolysis can provide the platform for all of the above forms of product.

Many thermal processing technologies for agricultural waste management require the water content of biomass to be low (<15 per cent) for proper operation. For these technologies the energy cost of drying can represent a significant reduction in process efficiency.

Moisture content is of important interest since it corresponds to one of the main criteria for the selection of energy conversion process technology. Thermal conversion technology requires biomass fuels with low moisture content, while those with high moisture content are more appropriate for biological-based process such as fermentation or anaerobic digestion.

The ash content of biomass influences the expenses related to handling and processing to be included in the overall conversion cost. On the other hand, the chemical composition of ash is a determinant parameter in the consideration of a thermal conversion unit, since it gives rise to problems of slagging, fouling, sintering and corrosion.

The post The Energy Value of Agricultural Wastes first appeared on BioEnergy Consult.

Peninsular Malaysia generates large amounts of wood and’ agricultural residues, the bulk of which are not being currently utilised for any further downstream operations. The major agricultural crops grown in Malaysia are rubber (39.67%), oil palm (34.56%), cocoa (6.75%), rice (12.68%) and coconut (6.34%). Out of the total quantity of residues generated, only 27.0% is used either as fuel for the kiln drying of timber, for the manufacture of bricks, the curing of tobacco leaves, the drying rubber-sheets and for the manufacture of products such as particleboard and fibreboard. The rest has to be disposed of by burning.

Palm Oil Industry

Oil palm is one of the world’s most important fruit crops. Malaysia is one of the largest producers and exporter of palm oil in the world, accounting for 30% of the world’s traded edible oils and fats supply. Palm oil industries in Malaysia have good potential for high pressure modern power plants and the annual power generation potential is about 8,000 GWh. Malaysia produced more than 20 million tonnes of palm oil in 2012 over 5 million hectares of land.

The palm oil industry is a significant branch in Malaysian agriculture. Almost 70% of the volume from the processing of fresh fruit bunch is removed as biomass waste in the form of empty fruit bunches (EFBs), fibers and shells, as well as liquid effluent. Fibres and shells are traditionally used as fuels to generate power and steam. Palm oil mill effluent, commonly known as POME, are sometimes converted into biogas that can be used in gas-fired gensets.

Sugar Industry

The cultivation of sugarcane in Malaysia is surprisingly small. Production is concentrated in the Northwest extremity of peninsular Malaysia in the states of Perlis and Kedah. This area has a distinct dry season needed for cost-efficient sugarcane production. Plantings in the states of Perak and Negri Sembilan were unsuccessful due to high unit costs as producing conditions were less suitable.

The lack of growth in cane areas largely reflects the higher remuneration received by farmers for other crops, especially oil palm. Over the past 20 years while the sugarcane area has remained at around 20000 hectares, that planted to oil palm has expanded from 600 000 hectares to 5 million hectares.

Other leading crops in terms of planted areas are rubber with 2.8 million hectares, rice with 670 000 hectares and cocoa with 380 000 hectares. Malaysia, the world’s third largest rubber producer, accounted for 1 million tons of natural rubber production in 2012. Like oil palm industry, the rubber industry produces a variety of biomass wastes whose energy potential is largely untapped until now.

The post Agricultural Biomass in Malaysia first appeared on BioEnergy Consult.

Among the various sources of renewable energy, bioenergy seems to be the most promising option for Malaysia. The National Biofuel Policy, launched in 2006 encourages the use of environmentally friendly, sustainable and viable sources of biomass energy. Under the Five Fuel Policy, the government of Malaysia has identified biomass as one of the potential renewable energy.

Malaysia produces atleast 168 million tonnes of biomass, including timber and oil palm waste, rice husks, coconut trunk fibres, municipal waste and sugar cane waste annually. Being a major agricultural commodity producer in the region Malaysia is well positioned amongst the ASEAN countries to promote the use of biomass as a renewable energy source.

Malaysia has been one of the world’s largest producers and exporters of palm oil for the last forty years. The Palm Oil industry, besides producing Crude Palm Oil (CPO) and Palm Kernel Oil, produces Palm Shell, Press Fibre, Empty Fruit Bunches (EFB), Palm Oil Mill Effluent (POME), Palm Trunk (during replanting) and Palm Fronds (during pruning).

Malaysia has approximately 4 million hectares of land under oil palm plantation. Over 75% of total area planted is located in just four states, Sabah, Johor, Pahang and Sarawak, each of which has over half a million hectares under cultivation. The total amount of processed FFB (Fresh Fruit Bunches) was estimated to be 75 million tons while the total amount of EFB produced was estimated to be 16.6 million tons. Around 58 million tons of POME is produced in Malaysia annually, which has the potential to produce an estimated 15 billion m³ of biogas can be produced each year.

Malaysia is the world’s second largest producer of crude palm oil. Almost 70% of the volume from the processing of fresh fruit bunch is removed as wastes in the form of empty fruit bunches, palm kernel shells, palm oil mill effluent etc. With more than 451 mills in Malaysia, this palm oil industry generate around 100 million dry tonnes of biomass. Malaysia has more than 2400 MW of biomass and 410 MW of biogas potential, out of which only a fraction has been harnessed until now.

Rice husk is another important agricultural biomass resource in Malaysia with good potential for power cogeneration. An example of its attractive energy potential is biomass power plant in the state of Perlis which uses rice husk as the main source of fuel and generates 10 MW power to meet the requirements of 30,000 households. The US$15 million project has been undertaken by Bio-Renewable Power Sdn Bhd in collaboration with the Perlis state government, while technology provider is Finland’s Foster Wheeler Energia Oy.

Under the EC-ASEAN Cogeneration Program, there are three ongoing Full Scale Demonstration Projects (FSDPs) – Titi Serong, Sungai Dingin Palm Oil Mill and TSH Bioenergy – to promote biomass energy systems in Malaysia. The 1.5MW Titi Serong power plant, located at Parit Buntar (Perak), is based on rice husk while the 2MW Sungai Dingin Palm Oil Mill project make use of palm kernel shell and fibre to generate steam and electricity. The 14MW TSH Bioenergy Sdn Bhd, located at Tawau (Sabah), is the biggest biomass power plant in Malaysia and utilizes empty fruit bunches, palm oil fibre and palm kernel shell as fuel resources.

The post Bioenergy Developments in Malaysia first appeared on BioEnergy Consult.

The most conventional method for collecting biomass is baling which can be either round or square. Some of the important modern biomass collection operations have been discussed below:

Baling

Large square bales are made with tractor pulled balers. A bale accumulator is pulled behind the baler that collects the bales in group of 4 and leaves them on the field. At a later date when available, an automatic bale collector travels through the field and collects the bales.

The automatic bale collector travels to the side of the road and unloads the bales into a stack. If the automatic bale collector is not available bales may be collected using a flat bed truck and a front end bale loader. A loader is needed at the stack yard to unload the truck and stack the bales. The stack is trapped using a forklift and manual labor.

Loafing

When biomass is dry, a loafer picks the biomass from windrow and makes large stacks. The roof of the stacker acts as a press pushing the material down to increase the density of the biomass. Once filled, loafer transports the biomass to storage area and unloads the stack. The top of the stack gets the dome shape of the stacker roof and thus easily sheds water.

Dry Chop

In this system a forage harvester picks up the dry biomass from windrow, chops it into smaller pieces (2.5 – 5.0 cm). The chopped biomass is blown into a forage wagon traveling along side of the forage harvester. Once filled, the forage wagon is pulled to the side of the farm and unloaded. A piler (inclined belt conveyor) is used to pile up the material in the form of a large cone.

Wet Chop

Here a forage harvester picks up the dry or wet biomass from the windrow. The chopped biomass is blown into a forage wagon that travels along side of the harvester. Once filled, the wagon is pulled to a silage pit where biomass is compacted to produce silage.

Whole Crop Harvest

The entire material (grain and biomass) is transferred to a central location where the crop is fractionated into grain and biomass.  The McLeod Harvester developed in Canada fractionates the harvested crop into straw and graff (graff is a mixture of grain and chaff). The straw is left on the field. Grain separation from chaff and other impurities take place in a stationary system at the farmyard.

For the whole crop baling, the crop is cut and placed in a windrow for field drying. The entire crop is then baled and transported to the processing yard. The bales are unwrapped and fed through a stationary processor that performs all the functions of a normal combine. Subsequently, the straw is re-baled.

The post Collection Systems for Agricultural Biomass first appeared on BioEnergy Consult.

At present, biomass technologies utilized in the country vary from the use of bagasse as boiler fuel for cogeneration, rice/coconut husks dryers for crop drying, biomass gasifiers for mechanical and electrical applications, fuelwood and agricultural wastes for oven, kiln, furnace and cook-stoves for cooking and heating purposes. Biomass technologies represent the largest installations in the Philippines in comparison with the other renewable energy, energy efficiency and greenhouse gas abatement technologies.

Biomass energy plays a vital role in the nation’s energy supply. Nearly 30 percent of the energy for the 80 million people living in the Philippines comes from biomass, mainly used for household cooking by the rural poor. Biomass energy application accounts for around 15 percent of the primary energy use in the Philippines. The resources available in the Philippines can generate biomass projects with a potential capacity of more than 200 MW.

Almost 73 percent of this biomass use is traced to the cooking needs of the residential sector while industrial and commercial applications accounts for the rest. 92 percent of the biomass industrial use is traced to boiler fuel applications for power and steam generation followed by commercial applications like drying, ceramic processing and metal production. Commercial baking and cooking applications account for 1.3 percent of its use.

The EC-ASEAN COGEN Programme estimated that the volume of residues from rice, coconut, palm oil, sugar and wood industries is 16 million tons per year. Bagasse, coconut husks and shell can account for at least 12 percent of total national energy supply. The World Bank-Energy Sector Management Assistance Program estimated that residues from sugar, rice and coconut could produce 90 MW, 40 MW, and 20 MW, respectively.

The development of crop trash recovery systems, improvement of agro-forestry systems, introduction of latest energy conversion technologies and development of biomass supply chain can play a major role in biomass energy development in the Philippines. The Philippines is among the most vulnerable nations to climatic instability and experiences some of the largest crop losses due to unexpected climatic events. The country has strong self-interest in the advancement of clean energy technologies, and has the potential to become a role model for other developing nations on account of its broad portfolio of biomass energy resources and its potential to assist in rural development.

The post Biomass Energy Potential in Philippines first appeared on BioEnergy Consult.

The most common agricultural wastes in the Philippines are rice husk, rice straw, coconut husk, coconut shell and bagasse. The country has good potential for biomass power plants as one-third of the country’s agricultural land produces rice, and consequently large volumes of rice straw and hulls are generated.

Rice is the staple food in the Philippines. The Filipinos are among the world’s biggest rice consumers. The average Filipino consumes about 100 kilograms per year of rice.  Though rice is produced throughout the country, the Central Luzon and Cagayan Valley are the major rice growing regions. With more than 1.2 million hectares of rain-fed rice-producing areas, the country produced around 19 million tons of rice in 2019.

The estimated production of rice hull in the Philippines is more than 2 million tons per annum which is equivalent to approximately 5 million BOE (barrels of oil equivalent) in terms of energy. Rice straw is another important biomass resource with potential availability exceeding 5 million tons per year across the country.

With the passing of Biofuels Act of 2006, the sugar industry in the Philippines which is the major source of ethanol and domestic sugar will become a major thriving industry. Around 380,000 hectares of land is devoted to sugarcane cultivation. It is estimated that 1.17 million tonnes of sugarcane trash is recoverable as a biomass resource in the Philippines.

In addition, 6.4 million tonnes of surplus bagasse is available from sugar mills. There are 29 operating sugar mills in the country with an average capacity of 6,900 tonnes of cane per day. Majority is located in Negros Island which provides about 46% of the country’s annual sugar production.

The Philippines has the largest number of coconut trees in the world as it produces most of the world market for coconut oil and copra meal. The major coconut wastes include coconut shell, coconut husks and coconut coir dust. Coconut shell is the most widely utilized but the reported utilization rate is very low.  Approximately 500 million coconut trees in the Philippines produce tremendous amounts of biomass as husk (4.1 million tonnes), shell (1.8 million tonnes), and frond (4.5 million tonnes annually).

Maize is a major crop in the Philippines that generates large amounts of agricultural residues. It is estimated that 4 million tonnes of grain maize and 0.96 million tonnes of maize cobs produced yearly in the Philippines. Maize cob burning is the main energy application of the crop, and is widely practiced by small farmers to supplement fuelwood for cooking.

If you want to know about sustainable rice farming practices, check this link.

The post Agricultural Wastes in the Philippines first appeared on BioEnergy Consult.