Critics’ case against wind energy

According to its critics, wind power is unreliable. The wind doesn’t blow all the time. It doesn’t blow on any predictable pattern. Wind turbines require some minimum wind speed for them to work at all. And if the wind is too strong, they can’t operate safely and must shut down.

Wind can cross one or the other of these thresholds multiple times a day. They operate at full capacity for only a few hours a year. So the theoretical capacity of a wind farm greatly exceeds its actual output.

The times turbines can generate electricity do not coincide with rising and falling demand for electricity. This variability creates problems for stabilizing the grid. Critics further claim that the wind industry can’t operate without massive government subsidies.

Wind power and South Australia blackout of 2016?

South Australia depends on wind energy for about 40% of its electricity. It suffered seven tornadoes on September 28, 2016. Two of them, with winds almost as fast as Hurricane Katrina, destroyed twenty towers that held three different transmission lines. Nine wind farms shut down.  Within minutes, the entire state suffered a massive blackout.

What contributed the most to the blackout? South Australia’s high dependence on wind power? The weather? Or something else?

Renewable energy skeptics quickly claimed the blackout justified their position. The wind farms simply failed to provide enough electricity in the emergency. Wind and solar energy, they say, are inherently unreliable. South Australia’s heavy reliance demonstrates an irresponsible policy based on ideology more than technological reality.

Certainly, the weather would have caused a disturbance in electrical service no matter what source of electricity. People near the downed transmission lines could not have avoided loss of power. But prompt action by grid operators makes it possible to bypass problem areas and limit the extent of the outage.

On closer examination, however, the correct answer to the multiple-choice question above is C: something else.

Wind turbines have “low voltage ride through” settings to keep operating for brief periods when voltage dips below the threshold at which they can operate correctly. If low-voltage conditions occur too frequently, the wind turbines have a protection mechanism that turns them off.

• Ten wind farms experienced between three and six low-voltage events within two minutes. But the turbines were operating on factory settings. No one performed any testing to determine good settings under local conditions.
• The agency that regulates the Australian electricity market knew nothing about the protection feature. It blamed the wind farms, but surely someone on staff should have been familiar with the default operation of the turbines. After all, the agency approved purchase and installation of the turbines. It had all the documentation.
• Two gas generating plants that should have supplied backup power failed to come online.

The weather caused a problem that became a crisis not because of technical limitations of renewable energy, but because of too many different organizations’ incompetence.

One homeowner in South Australia didn’t suffer from the outage. He didn’t even know about the blackout till he saw it on the news. He had to test the accuracy of the news reports by opening his oven and noting that the light didn’t come on.

It turns out he had installed solar panels just a few weeks earlier. And since power outages in his part of South Australia occur almost every month, he decided to install a Tesla Powerwall as well.

He can’t use it to power his entire house, but it takes care of the lights and the television. It stores enough electricity for 10 hours of off-grid power.

Big oil and wind power

International oil companies have not joined the chorus of wind-industry skeptics. Several of them, including Royal Dutch Shell, have begun to invest heavily in off-shore wind farms. Especially in the North Sea. Oil production there has steadily declined for about 15 years.

Exploring for new oil fields has become too risky and expensive. These oil companies have decided that investing in wind energy helps their cash flow and makes it more predictable.

Oil companies have more expertise in working on offshore platforms than do companies that specialize in wind energy. Instead of building a foundation for turbines on the ocean floor, at least one oil company has begun to explore how to mount them on floating platforms.

Traditional wind energy firms have been operating turbines in the North Sea for years, but the oil companies have begun to outbid them. Their off-shore expertise has helped them drive down their costs.

So far, American oil companies have shown less interest in wind farms. If they decide they’re in the oil business, they will eventually lose market share to renewable energy companies. If they decide they’re in the energy business, they’ll have to start investing in renewable energy. And if any decide to invest heavily in solar power besides or instead of wind, they will still be following the lead of Total, a French oil company.

For that matter, the coal business is dying. Perhaps some of them will have enough sense to invest in renewables to improve their cash flow.

The post A Blackout, Big Oil, and Wind Energy first appeared on BioEnergy Consult.

Applications of Epoxy Resins

Because of the versatile properties of epoxy resins, it is used widely in adhesives, potting, encapsulating electronics, and printed circuit boards. It is also used in the form of matrices for composites in the aerospace industries. Epoxy composite laminates are commonly used for repairing both composite as well as steel structures in marine applications.

Due to its high reactivity, epoxy resin is preferred in repairing boats that have been damaged by impact. Its low shrinking properties and ease of fabrication make it well suited for many tooling applications such as metal-shaping molds, vacuum-forming molds, jigs, patterns etc.

Use of Epoxy Resins in Clean Energy

A variety of industries have been actively trying to find a path that’s moving towards a society that puts less load on the the environment and also contributes towards reducing the carbon footprint. The accelerated use of epoxy resins in generating renewable energy has lead to a rise in its production demand. This is why the epoxy resin market is projected to witness a high demand and growth rate by 2022. Here are some of the sectors contributing to the production of clean energy and how they utilize epoxy resin for their functioning:

• Solar Energy

The harnessing of solar energy dates back to 700 B.C, when people used a magnifying glass to focus the sun’s rays to produce fire. Today solar power is a vigorously developing energy source around the globe. It not only caters to the rising energy requirements but also the need to protect the environment from the exploitation of exhaustible energy resources.

A piece of average solar equipment endures intense environmental conditions such as scorching heat, UV radiations, bitter cold,  pouring rain, hail, storms, and turbulent winds. To withstand such conditions, the sealing and mounting application of epoxy resins increase the environmental tolerance of the solar equipment.

With their high mechanical strength, impressive dimensional stability and excellent adhesion properties, they are used to protect the solar panels from a wide range of temperatures. Epoxies are cheap, less labor-intensive and easy to apply.

• Wind Energy

The global wind industry has quickly emerged as one of the largest sources of renewable energy around the world. The wind energy in the U.S. alone grew by 9% in 2017 and today is the largest source for generating clean energy in the country. With such a tremendous demand for wind power, the need for fabricating bigger and better wind turbine blades is also rising. The industry is in a dearth of long-lasting blades, that endure the harsh climatic conditions and wear tear and are able to collect more wind energy at a time.

Epoxy thermosets are used for making the blades more durable because of their high tensile strength and high creep resistance. Mixing of epoxy resins with various toughening agents and using them on the blades have shown positive results towards making the blades corrosion resistant and fatigue-proof.

• Hydropower

Hydropower is an essential source of renewable and clean energy. As the hydropower industry is developing rapidly, the solution for protecting the hydropower concrete surfaces against low temperatures and lashing water flow has also been looked into.

As a solution to this issue, epoxy mortar, a mixture of epoxy resins, binder, solvent, mineral fillers, and some additives has proven to be the most effective material used for surface protection. Owing to the properties like non-permeability, adhesive strength, anti-erosive nature, and non-abrasiveness, epoxy mortar paste has been used as a repairing paste in the hydropower industry.

Over the last few decades, epoxy resins have contributed immensely in the maintenance and protection of clean energy sources, helping them to become more efficient and productive.

Final Thoughts

While many argue that factors like a relatively high cost when compared to petroleum-based resins and conventional cement-mortar alternatives has affected the epoxy resin market growth, the fact remains that epoxy resin never fails to deliver top-notch and unmatchable results in the areas of application.

The post Applications of Epoxy Resin in Clean Energy Sector first appeared on BioEnergy Consult.

Solar Energy

Germany is the world’s biggest solar market and largest PV installer with a solar PV capacity of more than 49.78 GW at the end of 2019. The German new solar PV installations increased by about 4 GW in 2019. Germany has nearly as much installed solar power generation capacity as the rest of the world combined and gets about 5 percent of its overall annual electricity needs from solar power alone.

In 2019, German photovoltaic (PV) plants fed about 46.5 TWh into the public electricity grid, an increase of 1.7 percent compared to 2018.

Wind Energy

Germany’s wind energy industry is one of the world’s largest, and it is at the forefront of technological development.  Over half of all wind turbines in Germany are owned by local residents, farmers and local authorities which have tremendously improved the acceptance of wind turbines among local communities as they directly profit.

Being Europe’s primary wind energy market, Germany represents around 30 percent of total installed capacity in Europe and 12 percent of global installed capacity. Total wind energy capacity in Germany was 59.3 GW at the end of year 2019. Currently Germany is ranked third worldwide in installed total wind capacity with its share of total domestic electricity production forecasted to reach 25 percent by 2025.

Wind became the main electricity source in Germany for the first time in 2019. In eight months of the year 2019, the electricity generation from wind surpassed brown coal and in twelve months nuclear. Together wind and solar power plants generated a total of ca. 173 TWh electricity in 2019.

Biomass Energy

Biomass energy is making a significant contribution to renewable energy supply in Germany and accounts for about 5.5 percent of the total electricity production in the country. Germany is the market leader in biogas technology and is also Europe’s biggest biogas producer. Last year around 7,600 systems with a cumulative capacity of 3,200 MW generated 21.9 billion kWh in the country, thus consolidating Germany’s status as a pioneer in clean energy technologies.

Renewable Energy Investment

Germany’s plan to phase out all 17 of its nuclear power plants and shift to renewable energy by 2022 is the largest infrastructure investment program in Europe since World War II. The country’s transition from nuclear energy-based power network to renewable energy systems will require investments of much as $55 billion by 2030.

Germany is the world’s third largest market for renewable energy investment which and ranked 5th in the Bloomberg’s 2018 global renewable investment report with total investments of $10.5 billion in 2018. Sixty-five percent of investment in Germany was directed toward solar, with 29 percent directed to wind.

The country offers generous feed-in-tariffs for investors across all renewable energy segments which is attracting huge private capital in cleantech investments. In 2018, the majority of cleantech investment came from corporate investors across all sectors of the economy, including farmers, energy utilities, and industrial and commercial enterprises.

In 2019, the total electricity production in Germany from all renewable sources was about 237 TWh, an increase of 7 percent compared to 2018, and above fossil fuel carriers (207 TWh) for the first time.

The post Renewable Energy Trends in Germany first appeared on BioEnergy Consult.